Item:DL-7, ZERO CLEARANCE INSERT- NEW UNISAW W RIVING KNF SLOT

(0)No Reviews yet
$54.00
SKU: 300DL-7

This item is IN STOCK

Current Stock: 5

Leecraft DL-7 Zero-Clearance Table Saw Insert, 14-1/2" x 5" (Riving Knife Slot)

Please measure your Insert Opening 

For Delta New Unisaws
36-L336
36-L352
36-L552

Instructions:
  • Lower the blade completely.
  • Place insert in table with lug at rear and starter pocket located over blade.
  • Run leveling screws down until insert is stable and flush with table top.
  • Back out front end-adjustment screw and side adjustment screw to achieve a fit that is snug, yet removable.
  • If the insert will not go down flush with table top because it is resting on top of blade, then raise up using leveling screws until insert is sitting steady slightly above table top. This should provide adequate clearance for blade.
  • CUTTING THE BLADE SLOT (KERF)
  • Check that insert is fitted properly, and that blade is clear. Using a stick, reach under the table and rotate the blade manually to check for blade clearance.
  • Fully cover the insert with a board, and clamp at each end to the table saw top.
  • Re-connect power to saw. Switch on, slowly and cautiously raise blade up, to cut its way through the insert. KEEP HANDS OFF OF TABLE TOP, STAY CLEAR AND WEAR GOGGLES. Raise blade to maximum height at this time.
  • Lower blade, turn off saw, and remove board. Your insert is now ready for use!
  • Only recommended for use with carbide tipped blades and dados.
  • DADO BLADE - Use same procedures outlined above, but use additional caution due to excessive material being machined from insert during the slotting procedure.
  • Under certain conditions, an undesirable scraping noise may be generated by your saw blade. Planer type blades and/or excessive arbor run-out, and/or blade distortion, may be causing intermittent contact with the insert slot. To remedy this, remove the insert and slightly widen the slot using a file or sanding paddle.
  • Ideally, a separate insert should be used with each blade, dado stack, or angle set-up. This will insure a true "zero-clearance" effect and give you maximum benefit from your inserts.


Place insert in table with finger hole at front and starter pocket located over blade.

Ratings & Reviews

No reviews available

Be the first to Write a Review