Pages Menu
Categories Menu

Posted by on Feb 5, 2014 in Woodworking Tips and Tricks | 0 comments

How Do I Make a Rabbet Larger than 1/2″

Cutting a 1/4″ or even a 1/2″ rabbet with your router is no big deal but when you need a rabbet larger than 1/2″ then what.

Sure you could do it on the tablesaw with a Dado but what about a radius cut or a piece too large to handle on your table saw.

Amana has a rabbett bit called a Superabbet™. 

The superabbet bit comes set up to do a 5/8″ or 3/4″ rabbet but with an optional  67600 set of collars you can do rabbetts in 1/16″ graduations.  Always looking for a way to do the impossible   

For other tips and tricks  or to ask a question check out our blog @
www.circlesaw.com/blog/

picture of amana 49360 rabbet bit

Amana 49360 Superabbet

Post a Reply

Your email address will not be published. Required fields are marked *

sixteen − ten =