Categories

Manufacturers

My Cart

Your Shopping Cart is Empty

Leecraft DL-2 Zero Clearance Insert

Leecraft DL-2 Zero Clearance Insert
Price: Call for price
Product ID : 300DL-2
Weight: 1.50 lbs
Manufacturer: Leecraft
E-mail to a friend | Add To Wish List

Purchase

Call for price

Description

Leecraft DL-2 Zero Clearance Insert For Delta Saws

Please Verify your Throat Opening
Dimensions:
12-1/2"L x 3-3/4"W 

Fits DELTA 10" Direct Drive Table Saws
Models include #34-670, #34-740 (Super-10), #36-380 (XL-10) #36-600, QT-10, TS-300 & TS-350, JET #JSL-10TS SHOPLINE, JTS-10DD

 Instructions:

  • Lower the blade completely.
  • Place insert in table with finger hole at front and starter pocket located over blade.
  • Securely fasten insert down with the two (2) original screws. If necessary, enlarge clearance holes in insert to facilitate proper alignment of screws.
  • If insert is not adequately flush with table top, remove and shim up with tape or other material. Repeat step (3).
  • Check that insert is securely fitted, and that blade is clear. Using a stick, reach under the table and rotate the blade manually to check for blade clearance.
  • Fully cover the insert with a board, and clamp at each end to the table saw top. This safety precaution will also greatly reduce any chip-out on top surface of insert when blade penetrates.
  • Re-connect power to saw. Switch on, slowly and cautiously raise blade up, to cut its way through the insert. KEEP HANDS OFF OF TABLE TOP, STAY CLEAR AND WEAR EYE PROCTECTION. Raise blade to maximum height at this time.
  • Lower blade, turn off saw, and remove board. Your insert is now ready for use!
  • Only recommended for use with carbide tipped cutters.
  • DADO BLADE - Use same procedures outlined above, but use additional caution due to excessive material being machined from insert during the slotting procedure.
  • Under certain conditions, an undesirable scraping noise may be generated by your saw blade. Planer type blades and/or excessive arbor run-out, and/or blade distortion, may be causing intermittent contact with the insert slot. To remedy this, remove the insert and slightly widen the slot using a file or sanding paddle.
  • Ideally, a separate insert should be used with each blade, dado stack, or angle set-up. This will insure a true "zero-clearance" effect and give you maximum benefit from your inserts.

Comment on Facebook

Product Reviews

Login or Register to write the first review.